Kia Stinger: Brake system / Good braking practices
- Check to be sure the parking brake is not engaged and the parking brake
indicator light is out before driving away.
- Driving through water may get the brakes wet. They can also get wet when
the vehicle is washed. Wet brakes can be dangerous! Your vehicle will not stop
as quickly if the brakes are wet. Wet brakes may cause the vehicle to pull to
one side. To dry the brakes, apply the brakes lightly until the braking action
returns to normal, taking care to keep the vehicle under control at all times.
If the braking action does not return to normal, stop as soon as it is safe
to do so and call an authorized Kia dealer for assistance.
- Don't coast down hills with the vehicle out of gear. This is extremely hazardous.
Keep the vehicle in gear at all times, use the brakes to slow down, then shift
to a lower gear so that engine braking will help you maintain a safe speed.
- Don't "ride" the brake pedal. Resting your foot on the brake pedal while
driving can be dangerous because the brakes might overheat and lose their effectiveness.
It also increases the wear of the brake components.
- If a tire goes flat while you are driving, apply the brakes gently and keep
the vehicle pointed straight ahead while you slow down. When you are moving
slowly enough for it to be safe to do so, pull off the road and stop in a safe
place.
- If your vehicle is equipped with an Automatic Transmission, don't let your
vehicle creep forward. To avoid creeping forward, keep your foot firmly on the
brake pedal when the vehicle is stopped.
- Be cautious when parking on a hill. Firmly engage the parking brake and
place the shift lever in P (automatic transmission). If your vehicle is facing
downhill, turn the front wheels into the curb to help keep the vehicle from
rolling. If your vehicle is facing uphill, turn the front wheels away from the
curb to help keep the vehicle from rolling. If there is no curb or if it is
required by other conditions to keep the vehicle from rolling, block the wheels.
- Under some conditions your parking brake can freeze in the engaged position.
This is most likely to happen when there is an accumulation of snow or ice around
or near the rear brakes or if the brakes are wet. If there is a risk that the
parking brake may freeze, apply it only temporarily while you put the shift
lever in P (automatic transmission) and block the rear wheels so the vehicle
cannot roll. Then release the parking brake.
- Do not hold the vehicle on an incline with the accelerator pedal. This can
cause the transmission to overheat. Always use the brake pedal or parking brake.
A vehicle has the tendency to roll back on a steep hill when it starts to go
after stopping. The Hill-start Assist Control (HAC) prevents the vehicle from rolling
back by applying the brakes autom ...
The FCA system (if equipped) is designed to detect and monitor a vehicle ahead
or detect a pedestrian in the roadway through radar signals and camera recognition
to warn the driver that a collisio ...
Other information:
Repair procedures
Compression Pressure Inspection
If the there is lack of power, excessive oil consumption or poor fuel
economy, measure the compression pressure.
1.
Warm up and stop engin ...
Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
3.
Remove the glass motor (A) after loosening the screws a ...