Kia Stinger: Driveshaft and axle / Propeller Shaft Assembly

Rear Driveshaft Assembly

Repair procedures Removal 1. Remove wheel nuts, wheel and tire (A) from hub. Tightening torque: 107.9 - 127.5 N·m (11.0 - 13.0 kgf·m, 79.6 - 94. ...

Propeller Shaft

Repair procedures Inspection CV Joint and boots 1. Shift the transmission lever to Neutral. 2. Raise the vehicle off the ground, and support it wit ...

Other information:

Kia Stinger CK 2018-2025 Service Manual: Water pump

Components and components location Components 1. Water pump pulley 2. Water pump sub assembly 3. Water pump gasket 4. Water pump housing 5. Water pump housing gasket 6. Water inlet pipe gasket 7. Heater & bypass pipe Repa ...

Kia Stinger CK 2018-2025 Service Manual: Overhead Console Lamp

Repair procedures Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. Removal 1. Disconnect ...